After waiting for the writing to succeed, exit the EMMC drive letter, turn off the power of CM4NANO, unplug the Dupont cable and USB cable, and power on again, the system will start from EMMC.Use the win32diskimager tool to burn the mirroring system, as shown in the figure below.Open the SD Card Formatter software to format, as shown in the figure below:.You will see a drive letter in "My Computer", as shown in the figure below:.Open the rpiboot tool on the computer and power on CM4NANO, the tool will automatically execute the drive characterization of EMMC, as shown in the following figure:.Use a Dupont cable to short-circuit J55, and insert one end of the USB cable into J16 and one end into the computer, as shown in the figure below: Raspberry-pi-os-32-bit (opens new window) Insert the 12V/2A DC power cord into the J1 label of CM4NANO.
Please prepare the following equipment equipmentīoth ends are standard USB male headers, which are inserted into the J16 label. To flash the eMMC, you either need a Linux system (a Raspberry Pi is recommended, or Ubuntu on a PC) or a Windows system (Windows 10 is recommended).The programming steps for windows example are as follows: This guide explains how to write data to the eMMC storage. The Compute Module has an on-board eMMC device connected to the primary SD card interface. # Installation # Flashing the Compute Module eMMC
0 kommentar(er)
